EIBENSTOCK EHM 162 S Instrucciones De Servicio página 13

Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
Tool Change
Attention!
Before any work on the tool, disconnect the plug from the mains!
When inserting the tool, you could catch your hands. For this reason,
always wear protective gloves for changing the tool.
The work spindle of the machine has an M 14 - internal thread.
threads and front surface clean.
Please hold up with a jaw wrench 24 to remove the stirring rod.
Tool Protection
Wrong handling can cause damages on the tool. Therefore, the following
instructions should be observed:
Only use stirring rods which have a M 14 – external thread
diameter 180 mm max.) and are recommended by the producer.
Do not allow blocking of the tool.
Only use original accessories made by EIBENSTOCK.
Switching on and off
Switching-on: press the on/off switch
Switching-off: release the on/off switch
The stirrer is equipped with an electronic switch.
With this switch the speed can be regulated according to the pressure on the
button. The use is only recommended for the starting and running out of the
machine to avoid material flying around. A permanent operation with reduced
speed will cause an overload because the motor then gets less cooling air
and therefor the machine will be overheated much faster.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
Cross section in sq. mm
1.5
20 m
50 m
2.5
40 m
80 m
13
Keep