EIBENSTOCK EHR 20 S SET Instrucciones De Servicio página 14

In the event of a power interruption, release the locking switch by pressing the

on/off switch. This will prevent the power tool from restarting unintentionally
(risk of injury).
Do not use the power tool in a stand.

When working with this machine wear ear protectors, goggles, dust

mask, protective gloves and protective boots.
During use, always hold the machine with both hands and maintain a

safe standing position. Start up and run down the machine in the mixing
container only. Pay attention to the reaction moment of the machine.
For further safety instructions, please refer to the enclosure.
Electrical Connection
Before starting the machine, please check the correspondence between voltage
and frequency against the data mentioned on the identification plate. Voltage
differences of + 6 % and – 10 % are allowed. The Stirrer EHR 20 / 2.6 S is made
in protection class II. Only use extension cables with a sufficient cross section. A
cross section which is too small could cause a considerable drop in performance
and an overheating of machine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
Tool Change
Attention!
Before any work on the tool, disconnect the plug from the mains!
When inserting the tool, you could catch your hands. For this reason,
always wear protective gloves for changing the tool.
The work spindle of the machine has an M 14 - internal thread. Keep threads and
front surface clean. Please hold up with a jaw wrench 22 to remove the stirring
rod.
Tool Protection
Wrong handling can cause damages on the tool. Therefore, the following
instructions should be observed:
Only use stirring rods which have a M 14 – external thread
Cross section in sq. mm
1.5
20 m
50 m
2.5
40 m
80 m
13