EIBENSTOCK EHR 20 S SET Instrucciones De Servicio página 15

(diameter 140 mm max.) and are recommended by the producer.
Do not allow blocking of the tool.
Only use original accessories made by EIBENSTOCK.
Speed Selection
The machine is equipped with a mechanical two-speed gearbox.
required speed by pressing-in, shifting and engaging. The position of the lower
speed is in direction of the working spindle. Change the speed only when the
machine is not running, and support the speed-changing by slightly rotating the
work spindle.
Switching on and off
2
Note: For safety reasons, the on/off switch cannot be locked; it must remain
pressed during the entire operation.
To switch off the power tool, release the on/off switch.
The Stirrer EHR 20 / 2.6 S is equipped with an electronic switch. With this switch
the speed can be regulated according to the pressure on the button. Only use the
electronic switch when you want to start or stop the machine in order to avoid
material splashing around. A permanent use with reduced speed can cause an
overload because the motor then gets less cooling air and therefore the machine
will be overheated much faster.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only be appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist. Due to its design, the machine needs a minimum of care and
maintenance. However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.

During work, please pay attention that no particles get inside the machine.

In case of failure, a repair has to be carried out by an authorised service

workshop.
1
To start the power tool, first press the lock-off
button (1) , then press the on/off switch (2) and
keep it pressed.
14
Select the