Connecting The Device - imilab EC3 Pro Manual Del Usuario

Connecting the Device

Turn on the camera
Step 1: Insert the power supply cable into the camera's power supply port. Connect
the other end of the power supply cable to a power source.
Step 2: When connected to a power supply, the indicator light will show the camera's
status. When the indicator light is yellow, the camera is being turned on; when the
indicator light is flashing yellow, it is waiting to beconnected.
Insert a micro SD card
Ensure that the camera is disconnected from the power supply. Use a screwdriver to
remove the protective case and expose the micro SD card slot. The contact points of
the micro SD card should be facing the same direction as the camera. Insert the micro
SD card into the slot.
Note:
When inserting or removing the micro SD card, please disconnect the camera from the
power supply. Please use a micro SD card from a reputable manufacturer. The
recommended read and write speed of the micro SD card is at least U1/Class 10.
EN-06
MicroSD