Hilti NURON NPR 32 XL-22 Manual De Instrucciones página 29

3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Adjusting the stroke
5.4.1 Shorten stroke 3
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before inserting the crimping jaws.
The pressing tool's stroke can be shortened or extended to suit the size of the pressing jaws used.
1. Rotate the pressing head so that the release button is easily accessible.
2. Install the pressing/adapter jaw.
3. Insert the battery.
4. Press and hold down the control switch until the rolling actuator has almost reached the pressing /
adapter jaw.
5. Press and hold down the release button on the tubular guard.
6. Push the tubular guard toward the pressing / adapter jaw.
7. Release the control switch.
▶ The piston retracts only as far as the selected position.
5.4.2 Extend stroke 4
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before inserting the crimping jaws.
The crimping tool's stroke can be shortened or extended to suit the size of the crimping jaws used.
1. Rotate the crimping head so that the release button is easily accessible.
2. Insert the battery.
3. Press and hold down the release button on the tubular guard.
4. Push the tubular guard toward the rear into the desired position.
5. Release the release button.
▶ The piston retracts only as far as the selected position.
5.4.3 Position/stroke table
Pos. Stroke Crimping / pressing system
1 40 mm MegaPress (MP)
2 80 mm MegaPress (MP)
3 100 mm Industrial application
5.5 Installing the crimping/pressing/adapter jaw
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
*2321727*
5
2321727
Sizes Adapter
1/2 in ... 1 in —
1 1/4 in ... 2 in NPR PA 2
2 1/2 in ... 4 in NPR PA 3
English 23