cecotec BOLERO AGUAZERO 6800 STAINLESS STEEL Manual De Instrucciones página 39

ENGLISH
Height setting
Type 1
Fig. 18
- The height of the upper basket can be set easily to create more space for large utensils
on the upper or lower basket.
- To set the height of the upper basket, follow these steps:
- Pull out the upper basket.
- Remove the upper basket.
- Place the upper basket again on the upper or lower rollers.
- Push the upper basket inwards.
Type 2
Fig. 19
- To raise the upper basket, lift it at each end until the basket is positioned in the highest
position. There is no need to raise the adjustment handle.
- To reduce the height of the upper basket, adjust the handles on each side to release the
basket and lower it to the lowest position.
5.2 Lower basket
Fig. 20
- Place big and difficult to wash items in the lower basket, like pots, pans, lids, serving
dishes and bowls, as shown in the image.
- It is advisable to place platters and lids on the sides of the baskets so they do not block
the rotation of the upper spray arm.
- It is not advised to place dishes with a diameter of 19 cm or over in front of the detergent
compartment, as it may difficult its operation.
Fig. 21
6. Oven pan
7. Small dishes
8. Flat dishes
9. Soup plates
10. Platter
11. Small melamine dishes
12. Melamine bowls
13. Glass bowl
14. Dessert bowls
76
Setting the lower basket (Fig. 22)
- The spikes on the lower basket are used to hold the dishes and the tray as shown in the
image. (Fig. 22)
- You can lower them so there is more room for big utensils.
5.3 Cutlery tray
Fig. 23-24
1. Soup spoons
2. Forks
Knives
3.
Teaspoons
4.
5. Dessert spoons
6. Serving spoons
Serving forks
7.
Gravy ladle
8.
- Cutlery pieces must be placed in the cutlery tray separately one from another in the
correct position. Make sure utensils do not overlap, as this could cause malfunctioning.
- You can place utensils like blenders, mugs, etc. without affecting the operation of the
upper basket.
Always load sharp objects with the point upside down.
Adjusting the cutlery tray
Fig. 25
- Lift the left rack, adjust it to the lowest position, it will lie flat and the right rack will lie on
its side.
- Lift the right rack, now both are flat.
- Move the right rack from right to left, now they are both overlapping.
- Remove the right rack from the tray, there will be the left rack left.
Height setting
Fig. 26
Loosen the four buttons on the tray and push it down gently.
ENGLISH
77
AGUAZERO 6800 STAINLESS STEEL