Important - cecotec BOLERO AGUAZERO 6800 STAINLESS STEEL Manual De Instrucciones

ENGLISH
3. INSTALLATION
Step 1: Selecting the dishwasher location
Fig. 3
- 1. Connecting the electric supply, the water supply and the drain.
- 2. Space between the lower part of the cabinet and the floor.
- When placing the machine, do it in an area in which the tableware can be loaded and
unloaded easily. Do not place the dishwasher in an area in which room temperature is
below 0°C.
- If you want to install the dishwasher between two cabinets (Fig. 4) or under a worktop,
you must make sure there is enough space to do so and that the wiring and plumbing are
appropriate.
- Place the dishwasher near a tap, a water drain and a grounded electrical outlet.
Remember you should not modify the connections once the dishwasher is installed.
- You must leave at least a 5-mm space between the upper part of the dishwasher and the
cabinet, and the exterior door must be aligned with the piece of furniture.
- Follow the indications on image 3 on the dimensions the gap where you want to
install the dishwasher must have.
- WARNING: the worktop under which you want to install the dishwasher must be
stable in order to avoid imbalances.
- If you want to install the dishwasher in the corner of a cabinet, you must make sure there
is enough space to open the door completely. Fig. 5
- Place the moisture barrier tape under the surface in which the dishwasher is installed.
Fig. 5
1. Dishwasher
2. Dishwasher door
3. Minimum space of 5 mm
4. Cabinet
- Do not hold the device by its door or panel.
- Leave an appropriate distance around the machine to make its disconnection from the
mains and movement easier when cleaning it.
Step 2: Water supply hose connection
Fig. 6
Connect the water supply hose to a cold water tap, and make sure it is securely in place.
68
WARNING: use the water supply hose provided with your dishwasher, do not reuse the
water supply hose from your old dishwasher.
WARNING: open the tap and let water run through the water supply hose before
connecting it to the dishwasher.
WARNING: connect the water supply hose directly to the water inlet (1). The pressure
supplied by the inlet must be at least 0.04 MPa and at most 1 MPa. If the pressure is
over 1 MPa, you must install a pressure release valve in the connection (2).
When the connections are ready, open the tap completely and check if there is any
water leakage. Close the water supply tap after every washing programme.
Step 3: Draining hose connection
Fig. 7
1. Back of the dishwasher
2. Main cable
3. Water inlet
4. Drain hose hole
5. Drain hose
6. Worktop
- Next, connect the drain hose directly to a drain (B) or to an outlet with at least a 4-cm
diameter (A). This connection must be at least 50 cm and at most 100 cm over the floor
level.
- If the end of the drain hose is free, you should not be immersed in water, to avoid water
backflow.
- Make sure the drain hose is not twisted.
IMPORTANT: Utensils will not be washed correctly if you use a drain hose with over
4-m length.
Step 4: Electric connection
Connect the dishwasher to the electric circuit.
WARNING: make sure that the mains voltage matches the voltage stated on the rating
label of the appliance and that the wall outlet is grounded.
The dishwasher plug must be connected to a grounded socket. If you do not have a
grounded socket, a grounded installation must be carried out by a licensed electrician.
In case of ungrounded use, Cecotec shall not be liable for any malfunction or damage
that this may cause.
ENGLISH
69
AGUAZERO 6800 STAINLESS STEEL