Publicidad
SWAN-3
3) FCC Regulatory Information
a)
This module complies with the following standards:
-FCC part 15 Subpart C
b)
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
c)
Please notify certified ID by either one of the following methods on your product.
-Contains Transmitter Module FCC ID: WY7-SWAN3
-Contains FCC ID: WY7-SWAN3
d)
Since there is no space which indicates FCC ID on this module, FCC ID is indicated in
a manual. If the FCC ID is not visible when the module is installed inside another
device, then the module is installed must also display a label referring to the enclosed
module.
e)
CAUTION: Changes or modifications not expressly approved by the party responsible
for compliance could void the use's authority to operate the equipment.
f)
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC
transmitter rules) listed on the grant, and the host product manufacturer is responsible
for compliance to any other FCC rules that apply to the host not covered by the
modular transmitter grant of certification. The final host product still requires Part 15
Subpart B compliance testing with the modular transmitter installed.
g)
This product is certified as type of the portable device with FCC Rules. To maintain
compliance with RF Exposure requirement, please use within specification of this
product.
h)
The antenna used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
i)
Co-location of this module with other transmitters that operate simultaneously are
required to be evaluated using the FCC multi-transmitter procedures. When installing
this module to your final devices, please make sure to carry out all the necessary
evaluations according to the applicable guidelines like follows:
-for RF exposure: KDB 447498, KDB 996369 and any other relevant guidelines
-for EMC: KDB 996369 D04 and any other relevant guidelines.
j)
This module can change the output power depending on the circumstances by the
application software which is developed by module installer. Any end user cannot
change the output power.
k)
When you install this module to your final devices, please ensure that your final
composite product complies with the applicable FCC rules in reference to a guidance
in KDB 996369.
SHIMANO INC.
3-Mar-2020 Ver.0.3
SHIMANO INC.
4/8
Publicidad
