• Determine the appropriate installation location for the
thermostat
The thermostat must not be installed near or on
metal structures or surfaces including metal air
ducting that may be in the wall.
reduce the range of the wireless signal.
A. Refer to the Zoneline Owner's Manual to enable the
use of a wall thermostat. For AZ45/65 Series Models,
auxiliary mode 6 should be set to "6A".
B. Zoneline output is 24VAC. Be sure the jumper on the
wireless control card is on the AC position – jumper
is connecting "R" and "C" (common) pins. This is the
default position.
49-5000637 Rev. 0
Before You Begin
5