Initial Setup - Memco 452 861 Guia De Instalacion

CONNECTIONS
C B
CONNECTOR
A PWR
B USB
C TEL1/TEL2
D Antenna
E SIM
Switch
F
INSTALLATION
1. Location: It is recommended that the device be installed at the highest point
(e.g. motor room or top of shaft)
2. Connect the GSM antenna to the SMA connector being careful not to over-
tighten. The antenna should be placed a minimum of 3 metres from the
GSM unit
3. Insert the SIM Card into the SIM holder. Be sure the SIM is inserted in the
correct orientation with the gold contacts facing downwards.
4. Connect the Emergency Telephone to the TEL1 connector. If connecting
more than one emergency telephone either daisy chain the connection
between the telephones or use a junction block to split the connection from
the device.
5. Connect the power supply and turn the GSM Gateway on using the switch.
It is possible to connect up to eight Memcom
to the GSM.

INITIAL SETUP

A few seconds after power on, at the end of the self test, you will see one of the following situations.
LED Regular situation
Blinking / ON
GSM
Status ON
D A E
DESCRIPTION
Power supply connector
USB connector for upgrades
RJ11 FXS connectors
SMA/f connector for external GSM antenna
SIM connector
Switch for the device power off-on
or C100 emergency telephones
+
PIN required
OFF
ON
F
Emergency Telephone
Roaming/Virtual Operator
Flashing
ON