Samsung DVEG50R5400 Serie Manual Del Usuario página 35

03 Dryness
04 Temp.
05 Time
06 Wrinkle Prevent
07 Eco Dry
08 Damp Alert
Untitled-14 35
Press to select a dry level. You can select from 5 different options (Less to
More). Please refer to following recommendations to select the appropriate
dryness.
• For larger or bulkier loads, select More for complete dryness.
• For items that needs to lay flat or hang to dry, use Less to partially dry
items.
NOTE
This option is not available with REFRESH, WRINKLE AWAY, STEAM
SANITIZE , ACTIVEWEAR, TIME DRY, QUICK DRY, and AIR FLUFF.
Temperature can only be adjusted in TIME DRY and WRINKLE RELEASE
cycles.
Press to change the temperature of the current cycle. You can select from 5
different options (Low to High). Please select the appropriate temperature
depending on the items in the load.
• High: For sturdy cottons or those labeled Tumble Dry.
• Medium: For permanent press, synthetics, lightweight cottons, or items
labeled Tumble Dry Medium.
• Low: For heat sensitive items labeled Tumble Dry Low or Tumble Dry
Warm. Provides the lowest heated drying temperature possible.
Press to adjust the drying time for the Manual Dry cycles. This is not
available with the Sensor Dry cycles because the dryer determines the
drying time by sensing the current moisture level of the load.
Wrinkle Prevent provides approximately 180 minutes of intermittent
tumbling in unheated air at the end of the cycle to reduce wrinkling. Press
Wrinkle Prevent to activate this feature. The load is dry, and can be removed
at any time during the Wrinkle Prevent cycle.
This function is available with NORMAL and TIME DRY.
With the Eco Dry activated, drying takes a longer time but the power
consumption is reduced.
The drying time can be extended by up to 3 times depending on the
temperature and load. The Eco Dry function is enabled by default.
This alert is available for all Sensor Dry cycles except for SANITIZE and
ACTIVEWEAR. Available dry levels are Normal, More, and Extra.
If a load contains mixed fabrics, the Damp Alert indicator blinks when
average dryness of the items in the load is 80 % dry. This lets you take items
that you don't want fully dried or that dry quickly out of the dryer early while
letting others continue to dry.
English 35
2021-08-23 6:30:57