Preparing The Front Fan Opening; Preparing The Rear Power Connector; Location - Dometic CPV GMT1XXCCFT Manual De Instalación Y Funcionamiento

Preinstallation

6 .6 Preparing the Front Fan Opening

NOTICE: For vehicles with a Bose
exceed a drilling depth of 3/8 in. (10 mm) or damage could
occur to the enclosure wall of the speaker.
q
9 Using the Front Fan Template
Console Bin Front
q
Wall
1. Tape the front fan template to the inside, front wall of
the console bin.
2. Using a marker, trace the center point opening from
the template onto the console bin wall.
e
10 Drilling the Front Fan Opening
3.5 in. (89 mm) Hole
q
3/8 in. (10 mm)
w
Maximum Drilling Depth
10
sound system, do not
®
w
Front Fan Template
w
q
w
3.5 in. (89 mm)
e
Hole Saw Drill Bit
3. Remove the front fan template.
4. Use the 3.5 in. (89 mm) hole saw drill bit to drill an
opening for the front fan.
5. Vacuum any debris from the console and console bin
area.
6 .7 Preparing the Rear Power
Connector Location
q
11 Drilling the Rear Power Connector Opening
Equal Width
q
Hole Location for
w
the 12 V Rear Power
Connector
1. Identify the hole location for the 12 V rear power
connector.
The hole location is on the rear passenger side
I
of the console, measured 2 in. (50 mm) above
the black bracket and centered horizontally.
2. Using a marker, trace the center of the drill hole

location.

3. Use the 1 1/8 in. (29 mm) hole saw drill bit to drill an
opening for the 12 V rear power connector.
4. Vacuum any debris from the console and console bin
area.
GMT1XXCCFT Refrigerator
q
w
e
r
2 in. (50 mm)
e
Black Bracket
r
EN