Promaker PRO-SC1500 Manual De Instrucciones página 6

panels tend to sag under the panel
on both sides, near the line of cut
and near the edge of the panel.
e) Do not use dull of damaged
blades. Unsharpened or improperly
set blades produce narrow kerf
causing excessive friction, blade
binding and kickback.
f) Blades depth
adjusting locking levers must be
tight and secure before making
cut. If blade adjustment shifts while
cutting, ir may cause binding and
kickback.
g) Use extra caution when making
a "plunge cut" into existing walls
of other blind areas. The protruding
blade may cut objects that can
cause kickback.
Safety instructions
guard of saws
a) Check lower guard for proper
closing before each use. Do not
operate the saw if lower guard
does not move freely and close
instantly. Never clamp or tie
the lower guard into the open
position. If saw is accidentally
dropped, lower guard may be bent.
Raise the lower guard with the
retracting handle and make sure it
moves freely and does not touch the
blade or any other part, in all angles
and depths of cut.
and bevel
for lower
b) Check the operation of the
lower guard spring. If the guard
and the spring are no operating
properly, they must be serviced
before use. Lower guard may
operate sluggishly due to damaged
parts, gummy deposits, or a build-
up of debris.
c) Lower guard
retracted manually only for special
cuts such as "plunge cuts" and
"compound cuts". Raise lower
guard by retracting handle and as
soon as blade enters the material,
the lower guard must be released.
For all other sawing, the lower guard
should operate automatically.
d) Always observe that the lower
guard is covering the blade before
placing saw down on bench or
floor. An unprotected, coasting
blade will cause the saw to walk
backwards, cutting whatever is in its
path. Be aware of the time it takes
for the blade to stop after switch is
released.
Another safety rules
• Do not expose power tools to rain
or wet conditions. Water entering a
power tool will increase the risk of
electric shock.
• Do not abuse the cord. Never use
the cord to carry the tools or pull
the plug from an outlet. Keep cord
away from heat, oil, sharp edges
or moving parts. Replace damaged
should be
6