Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
them and upset the balance of
the ventilator, even knocking it
down.
After the fan is fully installed,
•
make sure that all fasteners are
secure to prevent the machine
from wobbling or falling.
Due to the natural motion of
•
the
fan,
may become loose. Check the
connections
a year, and if they are loose,
tighten them.
PRODUCT FEATURES
The contents of the package will contain
the following. See pictures 01 on page 4.
Packaging content:
1. Screws and washers for securing the
blades (fixed on the motor housing).
2. Screws for concrete ceiling
3. Screws and washers for wood joist
ceiling
4. Balance kit
5. Upper canopy
6. Support plate
7. Support rod
8. Lower canopy
9. Motor
10.
LED light kit
11. Blades
12. Lamp shade
13. Remote control
You can check the product features in table
01 on page 10.
ASSEMBLY AND INSTALLATION
Before installing the appliance,
make sure that the appliance is
unplugged from the mains.
Also disconnect the electrical
current from the installation of
your home. See picture 03 on page 6.
some
connections
at
least
twice
Before
assembly we recommend to
find the serial number and save
it. You can find this number,
referred to as "S/N" in a label
pasted on the outside of the motor housing.
You can write down this number in the
warranty document. It is mandatory to
provide the serial number to the Technical
Service for any intervention. (see picture
09 on page 9)
WHERE TO INSTALL
• Make sure that the place where the fan
is going to be installed is quite wide, as
this will allow a better air flow and that
the fan blades do not come into contact
with any object, minimum space of
0.76m on each side.
• Do not place the fan in an open space,
or in a room where there is moisture or
exposure to water.
• If the chosen location does not have
a suitable support beam capable of
supporting 45Kg, install a 2"x4" support
between the roof beams as a support
medium.
• Make sure that the bracket for hanging
the fan to the ceiling or other suitable
structure is capable of supporting at
least 45Kg, with the two long fixing
screws included. Make sure that at
least 30 mm of the screw is screwed
into the bracket.
• Only the fans with a support rod or bar
can be installed on sloping roofs where
the angle of inclination does not exceed
25º. This model cannot be installed on
sloping roofs.
Our fans are not designed to be installed
in plasterboard or false ceiling, as these
materials may not support 45kg.
Fastening screws (included) are designed
for use with the fan and are fastened to
wooden beams or concrete ceiling. If the
installation is carried out on a different
material, it is advisable to use the
appropriate fixing screws for that material
starting
with
EN
the
19
Publicidad
Tabla de contenido
