Operating Information; Setup Instructions; Operating Instructions; Air Quality Sensor - Nikken KenkoAir Manual De Operación

21. Do not operate near a kitchen vent.
22. Do not expose the KenkoAir Purifier to rain, or use near water, in a bathroom,
laundry area or other damp location.
23. Do not allow foreign objects to enter the ventilation or exhaust opening, as this
may cause electric shock or damage to the product. Do not block air outlets or
intakes. Keep these openings clean as specified in the instructions.
24. Do not sit, stand or place heavy objects on the KenkoAir Purifier.

OPERATING INFORMATION

Setup Instructions

Place the KenkoAir Purifier in an appropriate area (see precautions) and connect to a
power source.

Operating Instructions

Activating the unit
When the KenkoAir Purifier is first turned on, the air quality indicator will change color
several times to calibrate itself and stabilize after approximately 30 seconds. The blue
end of the scale denotes a low level of airborne contaminants. Red signifies a higher
concentration of pollutants. A sensor continually monitors the indoor air and any
alteration is reflected in the color of this indicator.
Fan speed
Press the fan speed button to choose the desired speed. In auto mode the fan speed is
controlled by the air quality sensor, and automatically adjusted as appropriate.
Timer
Pressing the timer button will set the KenkoAir Purifier to operate for three hours, and
pressing it again while the unit is operating in timer mode will cancel this setting.
Filter life indicator
When the filter life indicator is flashing, the filters require immediate replacement. After
new filters are installed, activate the unit, then depress and hold the indicator button for
three seconds to reset this function.

Air quality sensor

The air quality sensor that controls the unit in automatic mode may be adjusted to
increase or decrease sensitivity. The sensor switch is accessible when the front panel is
removed. There are three settings: low, medium and high. Setting the switch to LOW will
make the device more sensitive (reactive to a low concentration of air contaminants). A
setting of HIGH reduces the sensitivity so that in automatic mode the KenkoAir Purifier is
activated only when the airborne particle concentration is high.
17
-7-