Maintenance; Cleaning The Exterior; Cleaning The Prefilter; Filter Replacement - Nikken KenkoAir Manual De Operación

MAINTENANCE

CAUTION: When performing any maintenance operation, make sure the KenkoAir
Purifier is unplugged.
Never clean the unit by washing. Use a dry or damp cloth to wipe the exterior only. Do
not allow water to enter the unit.

Cleaning the exterior

Use a soft, dry or damp cloth to wipe the unit. Do not use solvents, chemical cleaners
or a stiff brush.
Cleaning the air inlet and outlet
Clean the air inlet and outlet with a soft brush.

Cleaning the prefilter

Be sure to unplug the unit before cleaning.
The reusable prefilter should be cleaned every two months, or when the filter life
indicator on the control panel is flashing.
1. Remove the front panel of the KenkoAir Purifier as described below in the
Replacing Filters section. Detach the prefilter as described.
2. Clean the prefilter by gently vacuuming or by immersion in warm water. If the
prefilter is very dirty, wash the surface with warm water mixed with a small amount
of dish soap.
3. If washed, allow the prefilter to dry completely before replacing it in the unit.
Reinsert all filters and reattach the front panel.

FILTER REPLACEMENT

The deodorizing filter and ULPA filter require regular replacement. Inspect at least
once every six months, or more often if used in an area with higher than average levels
of air pollution. Replace filters immediately if the filter life indicator is flashing.
IMPORTANT: The prefilter is reusable. Do not discard – clean and reinstall as
described above.
Do not operate the unit without filters in place.
Be sure to unplug the unit before replacing filters.
18
-8-