Quick Start; Connect Manner - Kohlt STIK 12 Manual Del Usuario

Quick Start

When mounting a speaker onto any stand, always ensure that the
stand is on a flat, level surface, with the legs fully extended. Be
sure to check that the maximum load weight for the stands is
greater than the weight of the ARRAY SYSTEMS loudspeaker.
Never use a stand with a maximum load weight lower than the
speaker. Do not attempt to mout more than one speaker on a stand
at one time.
The ARRAY SYSTEMS loudspeakers are heavy. It is recommen-
ded that a second person to help place the cabinet on a stand.
When the speaker is placed on a stand, always check the integrity
and center of gravity of the system If the speaker can be tipped
easily, or the pole is swaying, it is recommended that you lower the
height of the stand. Position the stand and route cables so that the
performers and the audience cannot tip over or trip on the system.

Connect Manner

1) Insert the 4 pcs of fixed legs of ST12WP into the fixed seat of ST12SA, It means the assembly
and connection of signal cable completed, details as below picture#1.
2) Snap the slot-terminal holder of ST12BM into the upper protruding holder of ST12WP and
then push ST12BM into slots along the opposite direction of grill. It means the assembly and
connection of signal cable completed. details as below picture #2.
3) Snap the slot-terminal holder of ST12TP into the upper protruding holder of ST12BM, and
then push ST12TP into slots along the opposite direction of grill. It means the assembly and
connection of signal cable completed . details as below picture #3.
4) Once assembly completed, no extra signal cable needed, based on the needs, user can rotate
ST12TP / ST12BM towards left or right within 90 degree limit.
ST12TP
ST12BM
ST12WP
ST12SA
5