Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Mode Configuration of transmitter programming in the receiver.
1
When you open the pedestrian door, relay 1 on the receiver will be activated
2
When you open the pedestrian door, relay 2 on the receiver will be activated
3
When you open the pedestrian door, the two relays will be activated at the same time
PRESS RPORG BUTTON
PRESS RPROG BUTTON
Autotest signal
Check the autotest output on the control panel, in stanby, to see whether the voltage is 0V (positive polarization) or 12/24V ac/dc
(inverted test input). Switch on the autotest signal of the panel and check that it has a maximum duration of 3 seconds.
Connection to a equipment with
autotest
Connection to a equipment without
autotest **
* Nota: Connect autotest only for used outputs.
** Where the autotest is not used, the system is not checked at the start of the operation, which means that security standard EN 12453 regarding the use of motorised
garage doors is, in some cases, not complied with..
Maintenance
Beeps and leds messages / errors indication table
B1/B2
Check
Beeps
Led
Led
ON
OFF
No beeps
OFF
OFF
4 beeps each
20 seconds
OFF
ON
No beeps
System Check
This function has to be used to check the operation and range of all the devices once the installation has been carried out.
Press the receiver's CHECK button for at least 1 second to enter check mode. The indicator light will come on and four beeps will be
heard.
Perform a complete door opening and closing manoeuvre. During the system check a beep will be heard every 1,5 seconds.
3200369_RCONTACT-R_EN_Rev03
LED TURNS ON
LED TURNS OFF & END PROG
Autotest output
Autotest output
in standby
activated
0V
12/24V
12/24V
0V
---
---
Equipment
Message / error
RCONTACT R
Detection of pedestrian door at open state
RCONTACT transmitter not programmed
Communication failure between RCONTACT R
and RCONTACT T
RCONTACT R
RCONTACT/T low battery
RCONTACT R
Check function. See coverage and signal quality
table.
PRESS TRANSMITTER PROG
Polarization type
Jumper
ATEST POL
Positive
Inverted
---
Led R1
Led R2
ON
OFF
OFF
ON
ON
ON
ONE BEEP & PROGRAMMED
ATEST1
OFF
Connected*
ON
Connected*
OFF
Not connected
Solution
---
Verify if it must be programmed and perform the
programming.
Verify the batteries of the emitter and if they are
charged, verify the radio signal with the Check
function.
Verify the batteries of the transmitter
---
ATEST2
Connected*
Connected*
Not connected
Page 2/3
Publicidad
Tabla de contenido
