Precautions For Use; Installation Height - SOMFY 1875141 Manual

Close the battery compartment ensuring you reassemble
the unit the right way round:
The base must be held with the fixing screws at the
■
bottom
The cover must be fitted with the arrow pointing
■
upwards

Precautions for use

Vertical installation
Install the detector vertically, with the upper detection
beams parallel to the ground.
If the detector is at an angle, the detection reliability
may be reduced.
The areas scanned by the external wall
movement detectors should not intersect.

Installation height

The installation height must be between 0.8 m and
1.2 m.
Leave at least 6 cm above the mount so that you can
open and close the cover.
Adjusting the detection beam
Install the detector with the upper and lower detection
beams parallel to the wall.
Caution: the rendering of the wall may affect the correct
positioning of the detector.
Avoid the lower detection zone facing reflective
surfaces (puddle, window, etc.).
The position of the detector must be chosen so
that the beams are not broken by moving objects
(branches, bushes, washing on a line, flags or swinging
shutters). If unstable objects cannot be avoided, consult
the Troubleshooting section at the end of this manual.
54
OUI
YES
0,8 < h < 1,2 m
OUI
YES
Copyright © 2018 Somfy Activités SA. All rights reserved.
NON !
NO!
> 6 cm
NON !
NO!
NON !
NO!
NON ! NO!