No partial flush
No flush or flush less after push down the button
Note: It is normal that water flows from the inside of the toilet in a moment after the flush.
Attention: Reduce the siphon to adapt it to the overflow level.
Defects caused by incorrect handling are not covered by the warranty.
Paper, plastic and other materials should be separated into the appropriate containers when throwing
It is recommended that the installation be carried out by an authorized installer.
Disconnect the water connection before being manipulated and make the product change only then.
FAULT AND RESOLVENT
Check the fill water level whether is higher than
the partial float. If not, adjust the water level
higher or adjust the float lower.
1. Check the button whether is pushed to the
proper position.
2. Check the button rod whether is too short. If
yes, adjust the adjustment rod's length.
EXCLUSIONS OF THE WARRANTY
ENVIRONMENTAL CARE
away the packaging.
Attention!
Installation
EN