ENGLISH
Important Information
The M110 SC bundle contains one M110 SC base station with Ethernet cable and one M110 SC handset, a rechargeable battery
pack, and one handset charger with power adapter.
Setting up, configuring, and using base station and handset
For information on setting up, configuring, and using the base station and the handset, please refer to the user's manuals listed on
the MSC-series product pages at www.snom.com.
Intended Use
The handset of the M110 SC is designed for professional use with the M110 SC base station. The M110 SC base station is designed
for professional use with the M110 SC handset. Any other use is considered unintended use. Any modification or reconstruction
not described in the user manual is considered unintended use.
Safety precautions
CAUTIONS:
Please read these precautions and the instructions on how to set up and use the phone thoroughly before using the phone. Save
this guide and do not give the phone to third parties without it.
The nameplate is located at the bottom or rear of the product.
Charger, power supplies/adapters, rechargeable batteries
Use only a power converter (AC/DC adapter) delivered with the device or Snom approved. Other power supplies may damage or
even destroy it.
Use only the rechargable batterie packs delivered with the device, model no. Ni-MHAAA550mAh 2.4V (NI-MHAAA550*2), 2.4 V, 550
mAh, supplier Yiyang Corun Battery Co., Ltd. Before use, please read the information on the safe and proper handling, use, disposal,
and replacement of the batteries on page 9.
• Power of M110 SC handset charger:
◦
EU: VTPL, model number VT05EEU06045, 100-240V, 50/60Hz, 150mA, 6V, 450mA
◦
UK: VTPL, model number VT05EUK06045, 100-240V, 50/60Hz, 150mA, 6V, 450mA
• Power of M110 SC base station:
◦
Power over Ethernet (PoE): IEEE 802.3af, Class 2.
◦
If PoE is not available, use the power adapter (not included in delivery, available separately):
- EU: Ten Pao, model no.: S005BNV0500080, 100-240V, 50/60Hz, 150mA, 5V, 800mA
- UK: Ten Pao, model no.: S005BNB0500080, 100-240V, 50/60Hz, 150mA, 5V, 800mA
Placement of base, handset charger, cables, and cords
• Warning: Power adaptors shall be installed near the equipment and shall be easily accessible.
• Mount the device only at heights not exceeding 2 m.
• Avoid placing the devices' cords where people may trip over them. Avoid placing the cords where they may be exposed to
mechanical pressure as this may damage it. If the power supply cord or the plug is damaged, disconnect the device and contact
qualified service personnel.
• Charger, power adapter, and cord are for indoor installation only. Not for outdoor installation!
• The operational temperature for base station and handset is between 0°C and + 40°C, humidity 95% non.-condensing. The
charging temperature for the handset is between 0°C and +40°C.
• Do not install product in rooms with high humidity (for example, in bathrooms, laundry rooms, damp basements). Do not
immerse product in water and do not spill or pour liquids of any kind onto or into any parts of it.
• Do not install product in surroundings at risk for explosions and do not use the handset in such surroundings (paint shops, for
example). Do not use the phone if you smell gas or other potentially explosive fumes!
• Install the base at a minimum distance of 100 cm (39") to persons and animals.
• Medical devices might be adversely affected. Please consider the technical ramifications when installing the devices in a
doctor's office, for example.
7