Machine Information; Technical Specifications - VONROC GP527AC Traducción Del Manual Original

• The pH of water must between 6.5 and 8.5.
• The temperature of the liquid conveyed may not
exceed 35 °C.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating plate.
Connecting to the power supply
Check that the power supply and plug used in
accordance with your machine. Have a look at the
rating plate on the machine. Any changes should
always be carried out by a qualified electrician.
Warning! This machine must be earthed. If
not properly earthed this machine can cause
an electrical shock. Be sure that the power
supply outlet is earthed. If there is any doubt,
have it checked by a qualified electrician.
Warning! Avoid contact with the terminals
on the plug when installing (removing) the
plug to (from) the power supply outlet.
Contact will cause a severe electrical shock.
Replacing cables or plugs
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qual-
ified persons in order to avoid a hazard. Immediately
throw away old cables or plugs when they have been
replaced by new ones. It is dangerous to insert the
plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm². When using a cable reel
always unwind the reel completely.
WWW.VONROC.COM

2. MACHINE INFORMATION

The automatic pump is intended for private use for
household water supply and irrigation of gardens, it
is not intended for commercial use. Explosive, cor-
rosive, flammable substances, sewage, salt water,
grease and oil must not be conveyed by the pump.
It is solely intended for pumping clear and rain
water. The particle sizes of the solids in the water
must not exceed the maximum particle size speci-
fied in the technical data.
This pump is not designed for continuous operation
(e.g. as a swimming pool or pond circulation pump).

TECHNICAL SPECIFICATIONS

Model No.
Pump housing
Voltage
Input power
Max. flow rate (Fig. C)
Max. pressure
Max. pumping height (Fig. C)
Max. self-priming suction
height
Max. particle size
Switch-on pressure
Default switch-on pressure
Dry run protection
Pressure gauge
Backflow preventer (pressure
switch)
Max. water temperature
Protection
Pressure connection (switch)
Suction connection
Recommended inner hose
diameter (suction hose)
Cable length
EN
GP527AC GP528AC
Stainless
Plastic
steel
230 VAC / 50Hz
800W 1000W
3300l/h 3500l/h
4 bar 4.4 bar
40m 44m
8m
1 mm (clean water)
1.5-2.5 bar
1.5 bar
Yes
Yes
Yes
35°C
IPX4
G1" external thread
G1" internal thread
25mm, 32mm, 38mm
1.2m
9