ION Party Rocker Max MK2 Guia Del Usuario página 8

TM
Stereo-Link : Syncing Two Party Rocker
1. Make sure both of your speakers are in Bluetooth pairing mode before attempting to link
them.
2. Press and hold the BOOM
mode and then do the same on the other unit. The Link icon will flash on the Display and
you will hear tones from both speakers to indicate they are searching for a speaker to
connect to.
Note: Speakers should be within 50' (15 m) of each other to properly sync. The closer the
speakers are, the faster they will sync.
3. Once a successful sync is established, the Link icon will appear solid and the tones will
stop sounding. Press the Bluetooth button on your Party Rocker
primary (left channel) speaker.
4. Press Play/Pause on Party Rocker
in stereo.
Note: Aux, Optical, and Radio modes are disabled when Party Rocker
another speaker.
5. Double-press the BOOM
Note: Party Rocker
enter Stereo-Link
secondary speakers to connect to.
Connecting an Audio Device Using the Aux Input
1. Connect a 1/8" (3.5 mm) auxiliary cable to the input on Party Rocker
and connect the other end to an audio device such as an MP3 or CD player.
2. Press the FM/Aux/Optical button three times to switch the audio source to Aux.
3. Press play on your device's music player. Use the Control Knob to adjust the Aux volume.
Note: Party Rocker
connected device. Lower the volume on your device if signal distortion occurs.
Using the Radio
1. Press the FM/Aux/Optical button to turn on the FM radio. Press once to access FM1
stations and press again to access FM2. The current audio source will be indicated in the
top right corner of the display.
2. Press the Next Track button to tune to the next strongest station signal. Press the
Previous Track button to tune to the previous strongest station. Press and hold both
these buttons to scan through each station one at a time in sequence.
Saving Presets:
1. Follow the instructions above to tune to the radio station you wish to save as a preset.
Press and hold the Play/Pause button until "P1" is visible on the display.
2. Use the Next Track and Previous Track buttons to select a preset slot from P1 - P10,
then press Play/Pause again to save the preset.
Note: You can also use the ION Sound XP
slots. See Operation > App Control
remote control for your Party Rocker
3. Press and then quickly release the Play/Pause button to cycle through the ten station
presets. All presets are set to the factory default 87.5 FM.
8
TM
button on one Party Rocker
TM
TM
button to break the link between speakers.
TM
Max speakers powered off in Stereo-Link
TM
mode the next time they are powered on and begin searching for
TM
Max speaker volume controls act independently from your
TM
Max Speakers
Max or your Bluetooth device to begin playing audio
TM
app to save a station to one of ten preset
to learn how to download and use the app as a
TM
Max speaker.
TM
Max to enter Stereo-Link
TM
Max to set it as the
TM
Max is linked to
TM
mode will automatically
TM
Max's rear panel
TM