VONROC PW508DC Manual De Instrucciones página 8

EN
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other bat-
teries could cause serious injury or damage the tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-4.
1. Pressure washer
2. Lance extension
3. Adjustable spray nozzle
4. Water inlet
5. Hose connector
6. Hose connector ring
7. Suction hose
8. Floating ball
9. Suction filter
10. Switch lever
11. Release button
12. Bucket clamp
13. Detergent bottle
14. Battery unlock button
15. Battery
16. Battery LED indicators button
17. Battery LED indicators
18. Charger
19. Charger LED indicators
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first use.
Assembly adjustable spray nozzle and lance exten-
stion (Fig. B)
1. Assembly the lance extension (2) on to the
pressure washer (1).
2. Assembly the adjustable spray nozzle (3) on to
the lance extension (2).
8
Inserting the battery into the machine (Fig. C)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (15) into the base of the ma-
chine as shown in Fig. C.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. C)
1. Push the battery unlock button (14).
2. Pull the battery out of the machine like shown
in Fig. C.
Checking the battery charging status (Fig. D)
• To check the battery charge status, push the
button (16) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more
charge the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. D)
1. Take the battery (15) from the machine.
2. Turn the battery (15) to upside down position
and slide it onto the charger (18) as shown in
Fig. D.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators (19) on
the charger (18) will lighten up and show the
charger status.
The charger has 2 LED indicators (19) which indi-
cate the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
Charger status
No power
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
finished
Battery charging in
progress
WWW.VONROC.COM