(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radioexempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter
may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is
not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le
présent émetteur radio peut fonctionner avec une antenne
d'un type et d'un gain maximal (ou inférieur) approuvé pour
l'émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de
sorte que la puissance isotrope rayonnée équivalente
(p.i.r.e.) ne dépasse pas l'intensité nécessaire à
l'établissement d'une communication satisfaisante.
This equipment complies with IC RSS-102 radiation exposure
limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a
minimum distance 20cm between the radiator and your
body.
Ce matériel est conforme aux limites de dose d'exposition
aux rayonnements, CNR-102 énoncée dans un autre
environnement.
Cet équipement doit être installé et utilisé à une distance
minimale de 20 cm entre le radiateur et votre corps.
KC
B급 기기: 이 기기는 가정용(B급) 전자파적합기기로써
주로 가정에서 사용하는 것을 목적으로 하며, 모든
지역에서 사용할 수 있습니다.
Safety Instruction
These instructions are intended to ensure that the user can
use the product correctly to avoid danger or property loss.
Laws and Regulations
The device should be used in compliance with local laws,
electrical safety regulations, and fire prevention regulations.
Electricity
In the use of the product, you must be in strict compliance
with the electrical safety regulations of the nation and
region. The equipment shall not be exposed to dripping or
splashing and that no objects filled with liquids, such as
vases, shall be placed on the equipment. Provide a surge
suppressor at the inlet opening of the equipment under
special conditions such as the mountain top, iron tower, and
forest. CAUTION: To reduce the risk of fire, replace only with
the same type and rating of fuse.
Battery
Do not ingest battery. Chemical burn hazard! This product
contains a coin/button cell battery. If the coin/button cell
battery is swallowed, it can cause severe internal burns in
just 2 hours and can lead to death. Keep new and used
batteries away from children. If the battery compartment
does not close securely, stop using the product and keep it
away from children. If you think batteries might have been
swallowed or placed inside any part of the body, seek
immediate medical attention. CAUTION: Risk of explosion if
the battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions. ATTENTION: IL Y A
RISQUE D'EXPLOSION SI LA BATTERIE EST REMPLACÉE PAR
UNE BATTERIE DE TYPE INCORRECT. METTRE AU REBUT LES
BATTERIES USAGÉES CONFORMÉMENT AUX INSTRUCTIONS.
Improper replacement of the battery with an incorrect type
may defeat a safeguard (for example, in the case of some
lithium battery types). Do not dispose of the battery into fire
or a hot oven, or mechanically crush or cut the battery,
which may result in an explosion. Do not leave the battery in
an extremely high temperature surrounding environment,
which may result in an explosion or the leakage of flammable
liquid or gas. Do not subject the battery to extremely low air
pressure, which may result in an explosion or the leakage of
flammable liquid or gas. + identifies the positive terminal(s)
of equipment which is used with, or generates direct
current. - identifies the negative terminal(s) of equipment
which is used with, or generates direct current.
Fire Prevention
No naked flame sources, such as lighted candles, should be
placed on the equipment. The serial port of the equipment
is used for debugging only.
Hot Surface Prevention
CAUTION: Hot parts! Burned fingers when handling the
not be touched without taking care. For device with this
sticker, this device is intended for installation in a restricted
access location, access can only be gained by service persons
or by users who have been instructed about the reasons for
the restrictions applied to the location and about any
precautions that shall be taken.
Installation
Install the equipment according to the instructions in this
manual. To prevent injury, this equipment must be securely
attached to the floor/wall in accordance with the installation
instructions. Never place the equipment in an unstable
location. The equipment may fall, causing serious personal
injury or death.
Power Supply
4
parts. Wait one-half hour after
switching off before handling parts.
This sticker is to indicate that the
marked item can be hot and should