Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Updating device firmware
To update the module firmware:
1.
select it
2.
right-click on the description (a pop-up with 5 sub-menus will appear)
3.
select "Download firmware" or
4.
click
which appears on the menu bar
Notes
1.
If you need to update the module from a version preceding 1.1.1 to a version higher than 1.1.1, you must
ALWAYS move to version 1.1.1 FIRST and then update to the desired higher version.
2.
The update packages consist of 2 files.
Simplebus 2
1.
First install the file Us2x_UAPP_HW0x0002_vX.X.X.vpk (at the end of the update the red LED with
the bell symbol will be lit steadily)
2.
Next, install the file Us2x_AUDI_HW0x0002_X.X.X.vpk
Both files must be used and installed in this order.
Simplebus 1
1.
First install the file Us1x_UAPP_HW0x0002_vX.X.X.vpk (at the end of the update the red LED with
the bell symbol will be lit steadily)
2.
Next, install the file Us1x_AUDI_HW0x0002_X.X.X.vpk
Both files must be used and installed in this order.
Restore backup
If the audio module is replaced, all programming is imported (only available if at least one additional module is
connected via flat cable). The procedure should be completed within one hour of removal of the old module
To restore the module configuration:
1.
select it
2.
right-click on the description (a pop-up with 5 sub-menus will appear)
3.
select "Recovery backup"
15
Publicidad
Tabla de contenido
