2.1.22. Power cord should be regularly examined
for signs of damage, and if the cord is damaged, the
appliance must not be used.
2.1.23. Do not touch the plug with wet hands.
2.2. Personal safety:
2.2.1. CAUTION: Do not leave the appliance unattended
during use as there is a risk of an accident.
2.2.2. Do not touch the heated parts of the appliance,
as it may cause serious burns.
2.2.3. This appliance is only for domestic use, not for
industrial or professional use. It is not intended to be
used by guests in hospitality environments such as
bed and breakfast, hotels, motels, and other types of
residential environments, even in farmhouses, areas
of the kitchen staff in shops, offices, and other work
environments.
2.2.4. This appliance is not intended for use by persons
(including children) with reduced physical, sensory,
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
2.2.5. This appliance is not a toy. Children should be
supervised to ensure that they do not play with the
appliance.
2.3. Use and care:
2.3.1. Fully unroll the appliance's power cable before
each use.
2.3.2. Do not use the appliance if the parts or
accessories are not properly fitted.
2.3.3. Do not use the appliance when empty.
2.3.4. Do not turn the appliance over while it is in use
or connected to the mains power supply.
2.3.5. Unplug the appliance from the mains power
supply when not in use and before undertaking any
cleaning task.
2.3.6. This appliance should be stored out of reach of
children.
2.3.7. Do not store the appliance if it is still hot.
2.3.8. Never leave the appliance unattended when in
use and keep out of the reach of children.
2.3.9. If, for some reason, the appliance was to catch
fire, disconnect the appliance from the mains power
supply and DO NOT USE WATER TO PUT THE FIRE
OUT.
2.4. Service:
2.4.1. Make sure that the appliance is serviced only by
suitably qualified technician, and that only original spare
parts or accessories are used to replace existing parts/
accessories.
2.4.2. If the power cord is damaged, the manufacturer
or its service agent or a similarly qualified person must
replace it to avoid a hazard.
2.4.3. Any misuse or failure to follow the instructions
for use renders the guarantee and the manufacturer's
liability null and void.
3. Instructions for use
3.1. Before first use:
3.1.1. During transportation, the incline angle of the
cabinet should not be over 45°C. Do not turn the
ice maker upside down. As this may damage the
compressor and sealed system.
3.1.2. Remove all packing material and carefully check
your ice maker to ensure it is in good condition and
that there is no damage to the ice maker or power cord
and plug.
3.1.3. The ice maker should be placed horizontally on a
level surface. To ensure proper ventilation for your ice
maker allow 150mm of space at the top, the back and
on each side. Do not install the ice maker near an oven,
radiator, or any other heat source.
3.1.4. Before using the ice maker for the first time,
please wait 2 hours after positioning it, and keep the
front lid open for at least 2 hours.
3.1.5. Ensure that the voltage indicated on the ice
maker corresponds with the voltage in your home.
3.2. Use and care:
3.2.1. Open the cover, remove the ice basket, and pour
water into the tank. Keep water level below the max
level mark.
3.2.2. Insert the plug into the wall socket, the
temperature will show XX°C.
3.2.3. Insert the ice basket and close the lid.
3.2.4. Press "ON/OFF" button on the control panel to
begin the ice making cycle. The screen with indicate an
end time countdown clock.
3.2.5. Select the ice cube size by pressing the "L"
(large) or "S" (small) button. If the room temperature is
lower than 15°C, it is recommended to select small ice
cubes to avoid the ice sticking together.
3.2.6. The ice making cycle lasts approximately 6 to 13
minutes, depending on the selection of ice cube size
and the room temperature. The recommended room
temperature is 10°C to 40°C.
3.2.7. If the water pump cannot inject water, the ice
maker will stop automatically, and the "ADD WATER"
indicator will be on.
3.2.8. When the "ADD WATER" indicator turns on,
Press the "ON/OFF" button. Open the lid and fill the
water tank to the max mark with water. Then press the
"ON/OFF" button again to turn on the machine. Allow
the refrigerant liquid inside the compressor at least 3
minutes to settle before restarting.
3.2.9. The ice maker stops when the ice basket is
full and the "ICE FULL" indicator will be on. Warning:
Direct sunlight or sunlight reflection may cause infrared