Charging Steps - HOMCOM Audi RS e-tron GT Ride-on 370-220V90 Instrucciones De Montaje

Step 1: Find the charging hole behind the cover in the left front fender.
Step 2: Insert the plug into the hole.
Step 3: Connect the charger to the power socket.
Components: PP plastic, k-carrageenan, generator, battery and iron castings.
Problem
The car does not start.
The battery does not
charge.
The car doesn't drive
far.
There's a slight noise
and the car heats
when charging.
The car operates at a
slow speed.

Charging steps:

Troubleshooting
Cause
- The battery is low.
- Failure to press the switch
button correctly.
- Power connector failure.
- Battery breakdown.
- Electrical devices are
damaged.
- Generator is faulty.
- Battery connector failure.
- Charger doesn't charge.
- Faulty charger.
- Battery isn't fully charged.
- Overused battery.
- This is normal.
- Overused battery.
- The battery is dead.
- The product has exceeded its
maximum load.
- Uneven driving surface.
19
Solution
- Ensure battery is fully
charged.
- Follow instructions when
using this product.
- Reinstall the power
connector.
- Change battery.
- Change electrical devices.
- Change generator.
- Reinstall the connector.
- Plug in the charger again.
- Change the charger.
- Ensure the battery is fully
charged.
- Change the battery.
- Nothing needs to be done.
- Change the battery.
- Ensure battery is fully
charged.
- Ensure the weight is below
25kg.
- Drive on a flat and even
surface.