UWELL CALIBURN X Pod System Manual Del Usuario página 9

displays from 5W to 20W. After 3 seconds of no operation,
the power value is automatically saved. The power display
area stops flickering and the power adjustment mode is
exited.
The recommended wattage range of the 0.8Ω coil is 13-18W.
The recommended wattage range of the 1.0Ω coil is 10-15W.
The recommended wattage range of the 1.2Ω coil is 9-13W.
6. Puff counter
The puff counter will only record vapes that last
over 1 second. The maximum is 999 puffs. Press
the fire button 4 times in a row, the puff record
flickers, and the puff clearing mode starts. One
press on the fire button will clear the puff to 000P,
and another press on the fire button will cancel the clearing
operation. Holding the fire button or 3 seconds of no operation
will stop flickering and exit clearing puff mode. The record will
remain the same as your last operation before the exit.
7. Resistance detection
Resistance detection of the coil would be done automatically.
Detection ranges from 0.8Ω to 1.2Ω.
a. "No Atomizer" indicates the device is fired
without a coil or the coil resistance is beyond
detection range.
b. "Atomizer short" indicates a short circuit of
resistance too low.
8. Low power protection
"Low Battery" indicates the device is fired with a
low battery.
9. Charging
Please use a Type-C charging cable with a 5V/2A adaptor.
During charging, the battery icon on the display shows a
moving state.
a. When the device is off, the display shuts down
after the device is fully charged.
b. When the device is on, the display shuts down
after the device is fully charged.
- 6 -