Replacement Of Batteries - Wilfa COOL 9 CONNECTED Manual De Instrucciones

Combination of buttons:
• Temperature display switchover function: Under OFF status, press "-" and
"Mode" buttons simultaneously to switch temperature display between °C
and °F.
• Light function: Under switch-on or switch-off state, you may hold "+"and
"FAN" buttons simultaneously to set the lamp on or off and send the code.
After being energized the lamp is defaulted on.

REPLACEMENT OF BATTERIES

1. Press the back side of remote controller on the spot marked with
the cover of the battery box along the arrow direction.
2. Replace two (AAA 1.5V) dry batteries, and make sure the positions of + and –
are correct.
3. Reinstall the cover of the battery box.
Note:
• During operation, point the remote-control signal sender at the receiving
window on unit.
• The distance between signal sender and receiving window should be no more
than 8m, and there should be no obstacles between them.
• Signal may be interfered easily in the room where there is fluorescent lamp
or wireless telephone; remote controller should be close to the unit during
operation.
• Replace new batteries of the same model when replacement is required.
• When you don't use remote controller for a long time, please take out the
batteries.
• If the display on remote controller is fuzzy or there's no display, please replace
batteries.
AIR CONDITIONER · COOL 9 CONNECTED
19
EN
, and push