Adjusting Depth Of Cutting; Cutting Feed; Adjustment Handlebar - Sima TRENCHER 60 Manual De Instrucciones Original

ENGLISH

7.5 ADJUSTING DEPTH OF CUTTING

The depth of cutting adjustment is made by wheel located on the top of
the machine (V, Fig.12). To lower the blade , we will turn the wheel
clockwise direction. In order to raise it, we will turn anticlockwise direction
as shown on the information drawings that carries machine.
To avoid variations in the depth of cutting due to unforeseen turns of the
steering wheel height adjustment, it provided for a basic locking
mechanism that immobilizes the steering wheel position (B, Fig.12).
Each time you go to change the height of the blades we will release the
steering wheel lock first.
The machine has a gas spring to help reduce the effort used to lift the
machine. Observed that the movement of the steering wheel is very
smooth and comfortable.

7.6 CUTTING FEED

Models with steering wheel for cutting progress reduce stress for the operator and awkward postures. Follow
the progress of cutting using the steering wheel, usually installed by default on the right side (V, Fig.14). You may
want to switch the steering wheel from left to right side, just remove the fastener (T, Fig.14) which secures the wheel
to the axle.

7.7 ADJUSTMENT HANDLEBAR

For greater convenience and to avoid awkward postures adjust the
handlebars to desired height.
If your model is shown in figure 15, loosen the handles (M, Fig.15) by
hand, adjust the height and retighten.
If your model is in figure 16, loosen the handles (M, Fig.16) by hand,
adjust the height and retighten.
The latter model has very effective anti-vibration handle, which prevents
long-term injury problems of circulation and reduces operator fatigue and
tiredness during the workday. The handlebar is mounted on elastic units
(U, Fig.16)
13