Bellman Visit BE1480 Manual Del Usuario página 37

Troubleshooting in brief
If
Nothing happens when the
transmitter is activated with the
test button (1).
The Visit receivers occasionally
indicate a fire alarm for no
apparent reason.
The smoke alarm can be
activated but the receivers are
not responding.
The receiver signals when no
transmitter is activated.
The smoke alarm beeps and
chirps in a different way from
that indicated above for no
reason.
For further information about the product in English, refer to the Appendix.
1 LED/Test button/sensitivity switch
2
Antenna
3 Temperature sensor
4
Battery compartment
5
Ceiling bracket
6
Radio Key Switch
7
Broadcast switch
8
Switch for BE1460 Visit Fire Alarm System
Try this
Change the battery. Use a Duracell

MN1604, Energizer 522 (alkaline) or
Ultralife U9VL-J-P (lithium).
Change the battery. Use a Duracell

MN1604, Energizer 522 (alkaline) or
Ultralife U9VL-J-P (lithium).
Change the radio key on all units in the

system. For further information see
Function/Radio Key
Check the battery in the receiver.

Check that the receivers are not placed

too far away by moving them closer to
the smoke alarm.
Check that the smoke alarm is set

to the correct Radio Key. For further
information see Function/Radio Key.
Change the radiokey on all units in the

system. For further information see
Function/Radio Key
The smoke alarm is defective and needs

to be sent for repair.
37
DE
DK
ES
FI
FR
GB
IT
NL
NO
PL
SE
App