Troubleshooting Guide - Bellman Visit BE1480 Manual Del Usuario

70
Troubleshooting
You can carry out a number of checks yourself before sending a product for
repair.

Troubleshooting guide

Problem
Nothing happens when the
transmitter is activated with the
Test Button (1).
The Visit Receivers occasionally
indicate a fire alarm for no ap-
parent reason.
The Smoke Alarm can be acti-
vated with the test button (1) but
the receivers are not responding.
The LED (1) blinks yellow or in a
strange manner.
The receiver signals when no
transmitter is activated.
The Smoke Alarm beeps and
chirps in a different way from that
indicated above for no reason.
Solution
Change the battery. Use a Duracell

MN1604, Energizer 522 (alkaline) or
Ultralife U9VL-J-P (lithium).
Change the battery. Use a Duracell

MN1604, Energizer 522 (alkaline) or
Ultralife U9VL-J-P (lithium).
Change the Radio Key on all units in

the system. For further information see
Function/Radio Key.
Check that the Smoke Alarm's antenna

is straight and points to the floor.
Check that the receivers are not placed

too far away by moving them closer to
the Smoke Alarm.
Check the battery in the receiver.

Check that all units in the Visit System

are set to the same Radio Key. For fur-
ther information see Appendix/Further
information/Settings/Radio Key.
Refer to the Guard Receiver User Manual

if the Smoke Alarm is connected to a sys-
tem with a BE1465 Visit Guard Receiver.
If the Smoke Alarm is not connected

to a system with a BE1465 Visit Guard
Receiver, check that the Guard Receiver
Switch (8) is in position 0.
Change the Radio Key on all units in the

relevant Visit System. There is probably
another system nearby with the same
Radio Key.
The Smoke Alarm is defective and

needs to be sent for repair.