Beper P302VIS003 Manual De Instrucciones página 5

For best results, it is advisable to use the device for maxi-
mum 2-3 times a week, do not use it daily and/or multiple
times a day.
Use Fig. B-D
Before first use, charge the battery completely, by inserting
the provided USB cable inside the connector found at the
base of the device. Connect the device to a wall socket (via
a USB adapter non included), or to other charging devices
(e.g. laptop, powerbank, PC, etc.) Once connected to the
charging source, all the LED indicators on the device will
start blinking, and will become fixed once battery is fully
charged. When the battery is dead, the device will buzz and
will automatically shut off; charge the battery to use the devi-
ce again. To switch the device on, hold the ON/OFF key for
a few seconds, the device will buzz and will turn on in "Ultra-
sonic cleaning" mode (Peeling ● Lifting) – the corresponding
LED indicator will light up. To change mode: press the ON/
OFF key once, to activate "EMS massage" mode (Power ●
Charge), the LED indicator will flash during operation; press
the ON/OFF key twice to activate "Ion+" mode (Ion+), the
corresponding LED indicator will light up; press the ON/OFF
key three times to activate "Ion-" mode (Ion-), the correspon-
ding LED indicator will light up; press the ON/OFF key four
times to go back to "Ultrasonic cleaning" mode (Peeling ●
Lifting). To switch the device off, hold the ON/OFF key for a
few seconds, the device will buzz and all the LED indicators
will turn off.
Operation modes
Choose the operation mode based on the treatment you
wish to carry out, and follow the suggested paths in fig. D
based on the area to be treated.
Ultrasonic cleaning (Peeling ● Lifting)
This operation mode allows a deep face cleaning, removing
impurities and contributing to make skin smoother. Before
starting, slightly wet your face with warm water and apply a
face cleansing solution, and rub gently to form a light foam;
for more effective cleaning, place the cleansing or massa-
ging silicone accessories on the shovel. When your face (or
area to be treated) is covered in foam, remove it with the
device making sure to move the shovel as shown in fig. B (if
present, remove the silicone accessory before proceeding).
Proceed for about 3 minutes, gently moving the device all
over your face Finally rinse your face with warm water.
Ion+
This mode is ideal for a deep cleansing of face pores. Apply
a cleansing lotion/toner on the skin, and massage making
sure to move the shovel as shown in fig. B; after about 3
minutes, rinse your face with warm water.
Important: do not use the silicone accessories for cle-
ansing or massaging, to avoid interfering with the ion
export process and compromising the efficacy of tre-
atment.
Ion-
This mode enhances the absorption of nutrients by the skin,
improving skin hydration. After properly cleansing your face,
apply a moisturizing cream and use the device making sure
to move the shovel as shown in fig. C, for about 3 minutes.