EIBENSTOCK EHR 20.1 R Instrucciones De Servicio página 15

Switching on and off
To start the power tool, first press the lock-off button, then press the on/off switch
and keep it pressed.
Note: For safety reasons, the on/off switch cannot be locked; it must remain
pressed during the entire operation.
To switch off the power tool, release the on/off switch.
The EHR 20.1 R is equipped with an adjusting wheel in order to preselect the
required speed. The adjusting wheel is on the top side of the switch handle.
I – minimum, IIIIIII – maximum
The integrated electronics automatically realises the soft start of the machine.
Please pay attention that in case of immediate switching OFF and ON again there
is a switch-on delay, because the motor first has to come to rest before it can
restart.
A permanent use with reduced speed can cause an overload because the motor
then gets less cooling air and therefore the machine will be overheated much
faster. The integrated temperature control protects the machine from thermal
overload. In such a case it switches off the motor. After a certain period of
cooling time the tool can be switched ON again.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist.
Due to its design, the machine needs a minimum of care and maintenance.
However, the following points always have to be observed:
▪
Always keep the power tool and the ventilation slots clean.
▪
During work, please pay attention that no particles get inside the machine.
▪
In case of failure, a repair has to be carried out by an authorised service
workshop.
Our after-sales service responds to your questions concerning maintenance and
repair of your product as well as spare parts.
EIBENSTOCK's application service team will gladly answer questions concerning
our products and their accessories.
15