ProKlima LG04-13AR Manual De Instrucciones página 127

1).open the water door,see Fig.1
2).pour water into water tank,see Fig.2
2. Set all the switches to OFF position, and then insert the plug directly into a standard AC socket-
outlet. Be sure plug fits tightly into outlet. Now the power pilot light will light on.
3. On/Off button
Press the button ON/OFF to start the fan
Note: the default fan speed and fan mode is Medium and Normal when press ON/OFF one time.
4. Speed button
Press the SPEED button to set the desired fan speed (Low/ Medium/ High).
As per the following sequence: medium
circulated and the speed pilot lamp will be on during the fan operating.
5. Air Swing(OSC) button
If you want to enlarge blast area in your room, press the vane button, the fan will blast your room in
large scope, the vane light will be illuminated. To stop vane, just press the vane button again, the vane
pilot light will go out. Moving the horizontal louvers either up or down can make further wind direction
enhancements.
6. Timer button
Set the time by pressing the timer button to select a desired timing level as follow, the range is from
0.5-7.5 hours. The pilot light corresponding to the selected timing level will be illuminated.
7. Mode button
The default setting is Normal wind when press button one time, then you can press the button Mode
again to choose your desired wind mode as per the following sequence:
The wind mode selecting can be circulated and the wind mode pilot lamp will be on during the fan mode
in operating.
8. Cooling button
124
high Low medium. The fan speed selecting can be
126