Tabla de contenido
Publicidad
Assembly
High pressure hose
• The high-pressure hose is already assembled to the reel
at the factory, the following instructions are for
replacement in case of damage:
• Connect the high-pressure hose (A) to the high-pressu-
re outlet (B) located on the inside of the reel. To connect,
pull the latch to release the padlock (C), insert the hose
connection into the outlet port as far as it will go and push
the latch to close the padlock securing the connection (D).
A
C
D
• Check that the connection
of (B
1
) the pressure washer
to the reel is properly
secured. The locking system is
the same as the connection of
the high-pressure outlet.
High-pressure gun
• Connect the free end of the high-pressure hose to the
high-pressure gun orifice (I). Press the button (I
insert the hose connector into the gun hole as far
as it will go and release the button to secure
the connector in place and release the
button to secure the connector in place.
• Screw the lance (K) onto the tip of
the high-pressure gun.
K
B
B
1
1
),
To ensure the safety of the appliance, use
WARNING
only original manufacturers or manufacturer's approved
replacement parts.
Water supply hose
• Before connecting the garden hose (E)
CAUTION
to the equipment, let the water run through it to expel
any objects inside. If the water supply is a well, the length
of the hose should be a maximum of 29.5 ft and an
additional filter should be used to prevent sand from
entering the system.
• It is recommended to use a reinforced hose (not
included) with standard connection with outside diameter
of 5/8", inside diameter of 15/32" and maximum 33 ft
length.
• Always completely untangle the garden hose and
high-pressure hose to avoid pressure fluctuations.
• Connect the garden hose (E, not included) to the quick
connector (F) and the filter (G) to the water inlet (H).
• The quick connector (F) is useful to easily connect and
disconnect the hose to the filter (G).
It is important that the connector has the
WARNING
filter (G) to prevent sand, silt, stones or any impurities
from damaging the pressure washer. Using the connector
without the filter will void the warranty.
WARNING
Disconnect the garden hose to prevent
damage to the filter when moving the machine from one
location to another.
G
I
I
1
F
E
H
ENGLISH
7
Publicidad
Tabla de contenido
