Start Up; Detergent Use - Truper Expert HILA-2000X Manual

Start Up

Turning On
1. Open the water faucet and keep it open all the time you are using the washer. Maximum inlet pressure: 174 PSI
2. Connect the plug into the power supply.
3. Tighten and hold the high-pressure gun trigger to release the air caught inside the washer. Release the trigger when the
water flow is constant.
4. Turn the switch (C) into the ON position. The motor will start momentarily and then it will stop.
1 2
Spraying
• Always hold the gun and lance with both hands to control
the sudden movement produced by the pressurized water.

Detergent Use

WARNING ATE
• Use only detergents designed for pressure washers.
Never use products with bleach, chlorine or other corrosive agents such
as solvents, trisodium phosphate products, ammonia or acid-based
cleaners. These products cause damage to the machine components.
• Remove the cap of the detergent tank (E) and add the appropriate
detergent. Do not add water to the detergent tank, the machine will
automatically mix the detergent with the water.
ATENC
WARNING • The machine will only suction detergent when
operating at low pressure. Mount the soap nozzle (black color) on the
lance.
• Squeeze the trigger, the detergent will come out mixed with the water.
If you need to adjust the detergent flow, turn the detergent switch (E), to
the left to decrease and to the right to increase, depending on the job to
be done.
• Apply detergent to completely cover the cleaning surface.
• Turn off the spray gun and allow the detergent to remain on the
surface to be cleaned for a couple of minutes.
• Switch to other nozzles to enter high pressure cleaning mode to rinse
and remove detergent from the surface.
3
C
3 4
D
• Aim the lance towards the floor and press
the gun trigger to start spraying.
• To stop spraying, release the trigger.
E
ENGLISH
9