Tabla de contenido
Publicidad
WARNING
• Before mounting or removing a nozzle on the metal lance, turn off the pressure washer, shut off the
water supply, depress the trigger to release pressure, and engage the safety latch to lock the trigger. Failure to comply with
any of these points could result in serious injury.
• Do not allow the metal lance to be pointed at your face when assembling or disassembling the nozzles,
WARNING
the quick connect system of the nozzles could accidentally launch the nozzle and cause injury.
• Insert the nozzle into the quick connector of the lance.
• Push the nozzle until the collar of the quick connector
collar rises.
• Pull the nozzle to make sure that the nozzle is properly
secured.
• To remove the nozzle, hold the nozzle by hand and
pull the quick connect collar.
The quick connector has a
WARNING
spring-loaded spring if you do not hold the nozzle
before pulling the collar, the nozzle will be ejected.
Nozzle Selection
• The pressure washer has different nozzles for different flow openings depending on the job to be done:
Nozzle
Red
Yellow
Green
Turbo
White
Black
8
ENGLISH
Flow Abrasion
Cement, Brick, Masonry
0°
15°
25°
40°
soap
Assembly
A
Exteriors, Hedges,
Patios, Terraces
Recommended Nozzle
Use with Caution
B
Boats, RV's,
Gardening Gear
Publicidad
Tabla de contenido
