Abask Q40S Manual Del Usuario página 10

4.Plug the car charger into the car cigarette lighter, the other end
plugs in the USB port of the dash camera.
Note:You can lay the extended charging cable along the edge of
the car windshield.
5.While installing the rear camera, please plug the rear camera in
the dash cam interface first, and then lay the cable on the ceiling
of the car from front to back. Install the rear camera on the back
of the car. The red cable connects to positive electrode of reverse
lamp while the black cable does not connect or it connects to the
grounding wire. Pay attention to the direction during installation.
6.Adjust the lens position to keep the lens and the ground flat.
7.Start the car engine; check whether the machine is installed
correctly or not.
Ⅶ. FAQ
1. Why can't it be turned on?
A: Please confirm whether the dash camera is charging or has been
connected to the car charger or not; When you start your car engine,
the dash camera will be turned on and record automatically.
2. Why does the inserted new memory card warn error?
A: If the recorder checked there is no system file in the new card,
it will warn an error, please format the memory card by this machine
and then it will work.
3. Why does the new-bought memory card have these problems:
cannot record, reacts slowly, no video file found and cannot play?
A: If the memory card has not been formatted in this
machine, or it is a low-speed or fake memory card, it
may have those problems mentioned above. So please
use an original high-speed memory card over Class 10.
4. Why loop recording does not work?
A:1) It's because you set the "G-sensor" and "Parking Guard" on.
These two functions will have the files locked, if there are too many
locked files, it will stop loop recording and warn that the memory
card gets full. You can choose to turn off these two functions or
adjust the sensitivity of the G-sensor to low. If you want to delete
those unimportant locked files, please unlock them first and delete
them on the dash camera directly, or connect the dash camera or
memory card to your computer, delete them on your computer.
2) There are many low-speed memory cards and inferior memory
cards sold on the market, if you use those cards above, it will also
result in full card. Given that the dash cam is writing the memory
card constantly during recording, if the card has such a problem,
it will also cause the error.
8