Care And Cleaning - Hamilton Beach 51180 Manual De Instrucciones

Care and Cleaning

Electrical Shock Hazard.
w WARNING
Disconnect power before cleaning. Do not immerse USB cable
assembly or base in any liquid.
1. Unplug USB Cable from the unit. Make sure LED Light is off.
2. Turn Base upside down and turn counterclockwise to unlock
Base. Lift up Base to remove.
3. Holding Base on its side, carefully rinse just Blades under running
water. It is okay for some water to get into top of Base. Do not
immerse Base in water or add to dishwasher.
4. Wipe Blender Base and control panel with a damp cloth or
sponge. To remove stubborn spots, use a mild, nonabrasive
cleanser.
5. Travel Lid, Blender Jar, and Blade Guard are dishwasher-safe on
top rack only. DO NOT use "SANITIZE" setting when washing in
dishwasher. SANITIZE cycle temperatures could damage your
product. Parts may also be washed with hot, soapy water. Care
should be taken when handling Blades on Base since Blades are
very sharp. Rinse and dry thoroughly. Do not soak.
Quick Clean:
To clean Blender Jar, add water to MAX level and a drop of liquid
dishwashing detergent. Place Base onto Blender Jar and turn
clockwise to tighten. Press START/STOP ( ) Button 2 times within
5 seconds. Blue LED Light stays on while blending. Blender will
automatically shut off after 30 seconds. Turn Base counterclockwise
and lift up to remove. Discard soapy water. Rinse Blender Jar with
clean, warm water.
How to check battery charge level:
Press and hold START/STOP ( ) Button for 3 seconds. The red light
will flash once to indicate you're in battery level mode. If LED Light is
solid blue, Blender is fully charged. If LED Light alternates blue and
red, Blender is 50% charged. If LED Light is solid red, Blender needs
charging.
6
Troubleshooting
Blender leaks.
• Blender Jar is not fully tightened. Remove Blender Jar, then
reinstall. Turn clockwise until blue LED Light flashes.
Does not blend well.
• Not enough liquid. Add at least 1/2 cup (119 mL) to MIN liquid line.
For best results, add liquid first and use at least 1/2 cup (water, milk,
juice, yogurt) to MIN liquid line. Then add solid ingredients like
protein powder, fruit and/or ice.
Blender will not blend and red LED Light is on.
• Blender has overheated. Let cool 20 minutes before blending.
Blender will not blend and red LED Light is flashing.
• Fruit or ice is stuck on Blades. Shake Blender several times to
dislodge food stuck on Blades. Press START/STOP ( ) Button 2
times to restart blending.
STORAGE: When not in use, Travel Lid can be stored one of 2
ways:
1. On Blender Jar.
NOTE: Do NOT attempt to carry Blender by Travel Lid in this
configuration.
2. On Blade Guard.
3. USB cord can be stored inside Blade Guard.
1 2