Care And Cleaning - Hamilton Beach 58600 Manual Del Usuario

Care and Cleaning

1. Unplug.
2. Remove Blender Jar and Lid. Rotate Jar Collar
counterclockwise until Collar and Cutting Blade Assembly
come apart from Blender Jar. If Jar Collar is uncomfortable to
hold, protect hand with a rubber grip, towel or oven mitt.
3. Wipe Blender Base, control panel, and cord with a damp cloth
or sponge. To remove stubborn spots, use a mild, nonabrasive
cleanser.
4. Blender Jar, Lid with Filler Cap, and Jar Collar are dishwasher-
safe. Wash Cutting Blade Assembly in hot, soapy water. Rinse
and dry.
5. DO NOT use "SANI" setting when washing in the dishwasher.
"SANI" cycle temperatures could damage your product. Parts
may also be washed with hot, soapy water. Rinse and dry
thoroughly. Do not soak.
Troubleshooting
Ingredients will not mix properly.
• Check to see if enough liquid has been added to ingredients.
Mixture should be fluid and free-running at all times.
• Solid pieces are too large.
• Jar is too full. Do not fill past highest (6 cups/1.4 L) graduation
marking.
• Cutting Blade Assembly blades are not sharp or are damaged.
Inspect Jar and Cutting Blade Assembly daily.
• Select speed to create a fluid blend.
• Thicker mixtures should run on slower speeds for best mixing
performance.
• Set speed one speed lower and try blending again.
w WARNING
Electrical Shock Hazard. Disconnect power before cleaning.
Do not immerse cord, plug, base, or motor in water or other liquid.
w WARNING
Burn Hazard. Metal parts under blender jar get hot after
extended use.
Cleaning Blender Jar:
Add 3 cups (710 ml) warm water and add two drops of dish soap. Press
pulse button. Rinse and dry thoroughly.
Blender smells like it is burning.
• Turn off Blender and allow unit to cool.
• Although motors are tested during the manufacturing process,
heavy use may cause curing of motor windings. The smell may
quickly dissipate after a few heavy uses.
• If smell continues after additional heavy uses, contact Customer
Service.
There is grease around bottom of Blender Jar or on countertop.
• Monitor problem and source. This may indicate an issue with jar
bearings.
• Contact Customer Service if condition persists.
7