hillvert HT-LOGAN-750B Manual De Instrucciones página 29

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 116
m) To reduce the effects of noise and vibration on human health, you should: limit
the working hours, use low vibration and noise modes, and wear personal
protective equipment.
2.4.
Safe use of the device
a)
Do not overload the device. Use tools that are suitable for the application. A
correctly selected device will do a better and safer job for which it was
designed.
b)
Do not use the device if the ON/OFF switch does not function properly (does
not turn on and off). Devices that cannot be controlled by the switch are
unsafe, cannot operate, and must be repaired.
c)
Before adjusting, cleaning or maintaining the machine, turn it off, wait at least
5 minutes or until it has cooled down, and then disconnect the spark plug wire.
d)
Keep unused equipment out of the reach of children and out of the reach of
anyone unfamiliar with the device or this instruction manual. These devices is
dangerous in the hands of inexperienced users.
e)
Keep the device in good working condition. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the device). If damaged,
have the device repaired before use.
f)
Keep the device out of the reach of children.
g)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
h)
To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
i)
Do not touch any moving parts or accessories unless the device is unplugged.
j)
Do not leave the device switched on unattended.
k)
Clean the device regularly to prevent permanent dirt build-up.
l)
The provided value of vibration emission is measured according to the
standard measurement methods. The value of vibration emission may change
if the device is used under different environmental conditions.
m) Do not obstruct the air inlet or outlet.
n)
The device is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
o)
Do not tamper with the device to alter its performance or design.
p)
Keep the device away from sources of fire and heat.
q)
Do not block the ventilation openings of the device!
r)
When using the device, move slowly and steadily. It is not allowed to run with
the device.
s)
To avoid fire hazards, keep leaves, grass, and other combustible materials
away from the hot engine and muffler.

Publicidad

Tabla de contenido
loading

Tabla de contenido