Cleaning And Maintenance - hillvert HT-LOGAN-750B Manual De Instrucciones

• The device vibrations may cause the fuel filler cap to loosen or to twist off
when incorrectly locked and lead to leakage. To avoid this situation, make
sure the filler cap is properly tightened before each use.
• Use the full extension of the blower nozzle so that the air stream is as close
as possible.
• When working in vacuum cleaner mode, in order to use the device, first,
attach the leaf bag!
Empty the leaf bag systematically. Do not to pull in sharp, wet elements, etc.
•
that may damage the device.
If you notice a decrease in the power of the machine, verify the condition of
•
the air filter. If necessary, clean or replace it with a new one.
3.4.

Cleaning and maintenance

a) Before cleaning, adjustment, replacement of accessories, and when the device
is not in use, turn off the engine and disconnect the spark plug wire and wait
until the device has cooled completely.
Wait until the rotating parts stop.
•
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all the parts should be dried well before the device is used
again.
d) Store the device in a dry and cool place protected from moisture and direct
sunlight.
e) Do not spray the device with a stream of water or immerse it in water.
f) Make sure that no water enters through the ventilation openings in the
housing.
g) Clean the ventilation openings with a brush and compressed air.
h) Perform regular inspections of the device checking technical fitness and any
damages.
i) Use a soft, damp cloth for cleaning.
j) Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the
device is made.
k) Do not clean the device with acidic substances, medical products, diluent,
fuel, oil or other chemicals as this may cause damage to the device.
Spark plug
•