PROZIS Satin Manual Del Usuario página 5

EN
• After cleaning, allow the foil frame and the cutters to air dry before closing the foil frame
and the shaver head. Replace the shaver head on the main unit – it will click into place.
Clean the surface of the main unit with a dry towel.
Monthly deep cleaning:
1
4
1. Remove the inner cutter lock away from the cutters.
2. Remove the cutters.
3. Carefully wash off any residue.
4. Replace the inner cutters by matching them with the corresponding outer cutter hub.
5. Place the inner cutter lock back into position by sliding it back into the holder until it clicks
into place.
6. Mount the cutter head back onto the main unit.
How to clean your trimmer head:
Since the trimmer blades are specifically made for a very special use, they should always be
handled with care. Each time you finish using the trimmer, remove the supplied cleaning
brush and brush off any loose hair left on the blades. Afterwards, rinse them with water only,
allow them to air dry, and store the trimmer until you need to use it again.
When shaking off any excess water, hold the main unit firmly to avoid releasing the head
assembly or dropping the unit.
Do not use a dryer or a heater to dry the trimmer. This may result in malfunction or damage to
the trimmer.
How to clean your facial brush head:
Separate the brush head from the brush holder. Clean with warm soapy water.
Dry the brush with a towel.
8
2 3
5 6
Storage:
• Store the product in a dry environment, protected from dust and direct sunlight.
• If the appliance is not going to be used for a long period of time, you should remove the
battery to prevent leakage.
• Store your appliance inside the original case provided.
INSTRUCTIONS
How to use
Battery installation:
1. Twist the bottom housing to the left, align the
2. Insert the battery (not included).
3. Slide the bottom housing back into place and align the
4. Make sure the battery is installed correctly, according to the polarity symbols (+ and -).
5. Remove the battery when depleted or if the trimmer has not been used for a long period
of time.
6. Clean the battery contacts and also those on the device prior to installing the battery.
7. Promptly remove the depleted battery.
8. Always purchase the correct battery, which will be the one suitable for the device.
Trimmer Head Replacement:
1. Make sure the unit is switched off.
2. Twist the head counterclockwise and align the triangles.
3. Switch the head attachment, turn the head clockwise and align the triangle with the "O"
marking.
How to use:
triangles and pull.
.
EN
9