ARVA NEO BT PRO Guía De Utilización página 10

• If the displayed distance fluctuates between 0.5 m and 1.5
m and you are positioned correctly 1 m from the device be-
ing checked, the transmit power is correct, and your device
will emit a standard search "beep."
• If the distance displayed seems to be inconsistent, this
means that the transmit power may not be correct and that
the device being checked should be taken care of by the
after-sales service
When the group check is complete, press the marking button
to switch to transmit mode. Be sure to test the group leader's
device using one of the devices previously tested. GROUP
CHECK mode can be accessed again at any time from trans-
mit mode by pressing the "+" and "-" buttons simultaneously.
The device automatically switches to transmit mode after 8
minutes for safety reasons.
3.2/ RESCUE
3.2.1/ STEP 1: SIGNAL SEARCH
Take your NEO BT PRO out of its holster and put it into search
mode. Then, proceed across the avalanche in search of a
signal using the techniques shown in one of the 2 diagrams
below. The screen displays the signal search icon.
10
It is important to point your transceiver in the direction of
the avalanche, parallel to the slope. Listen carefully for the
first signals, paying attention to external visual clues (poles,
skis, clothing) at the same time. As soon as the first signal
is detected, a "VICTIM" pictogram will appear on the screen
automatically.
The "VICTIM" pictograms are located on the left of your
screen; the "+" pictogram indicates that there are more than
4 burial victims.
EN