Maintenance & Cleaning - Delabie 510579 Instrucciones De Montaje

OPERATION
• The soap dispenser with soft-touch operation is compatible with vegetable-based liquid soap with
a maximum viscosity of 3,000 mPa.s.
Do not use with hydroalcholic gel.
• Push-button soap dispenser with watertight anodised aluminium lid and plastic tank.
• To open the lid (Fig. A) :
- Use a pointed tool to press  on the concealed button
- Open the lid .
• Fill the tank from above.
INSTALLATION
• Fix the lower part of the dispenser by clipping onto the wall bracket (Fig.s B to E).
Check that the marks are level using the locator
• Fix the upper part of the distributer (Fig.s F to K).
REMEMBER
Our products must be installed by professional installers in accordance with current regulations and
recommendations in your country, and the specifications of the fluid engineer.
Do not shake the dispenser.
Do not block the soap outlet.
MAINTENANCE & CLEANING
Do not use abrasive, scouring powder, chlorine or any other acid-based cleaning products.
Cleaning the anodised aluminium exterior surface:
• Clean with mild soapy water using a clean cloth or a sponge.
Cleaning the pump and the tank:
• Open the lid (Fig. A).
• Remove the tank (Fig.s L to R).
Press on the two clips at the back of the tank to remove the base  (Fig. Q).
• Remove the pump (Fig.s S to W).
Press on either side of the pump to unclip it  (Fig. U).
Use a DELABIE removal key, ref. 222429 (not supplied with the product) (Fig. W).
• Clean with hot water.
Check that the O-ring is present underneath the tank every time you access the pump
For the UK market only: Tel. 01491 821 821 - email: technical@delabie.co.uk
For all other markets: Tel. +33 (0)3 22 60 22 74 - email: sav@delabie.fr
After Sales Care Support:
The installation guide is available on: www.delabie.co.uk
The installation guide is available on: www.delabie.com
.
in holes on the level marker (Fig. C).
EN
(Fig. R).