Descargar Imprimir esta página

Daspi CENTRAL PARA TOLDO Manual página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

CONTROL BOARD FOR AWNINGS
OPEN/STOP/CLOSE external input
Also, RS MULTI can work by external input, with OPEN/STOP/CLOSE function.
The inputs are connected via switch with AC power supply. Below in point 10
is the explanation of how to work by external input.
6. Motor output
The 3 outputs U, V and W are for connecting the motor. The capacitor must
be wired between the outputs V and W, Open and Close according to point
11 below.
7. Maneuvers time programming
Before programming, check limit switches in case they are installed. The
awning should be closed.
The orders are given by pressing the remote previously installed or the OSC
button.
1. Press OSC 2 seg this means maneuver programming starts.
2. The opening maneuver starts. If limit switches have been installed,
maneuver ends by the opening limit switch contact, if not, the order must
be given at the end of the maneuver.
3. Control board waits for the starting of closure maneuver. If it is activated
within 5 seconds, manual mode will be activated; if it is pressed after that 5
seconds, automatic closing mode will be set, the time spent from the end
of opening to closing maneuver starts, it is the pause time programmed.
4. If limit switches have been installed door stops by closing limit switch
contact. If not, an order is required. the end of closing maneuver and
maneuver time programming finishes.
Repite the procedure if the maneuvers are not programmed correctly.
8. Entry one remote button:
1. Press button RMT until LED L1 turns on. Press any button on the remote
twice, LED L1 will flash quickly for 4 seconds. The remote is programmed.
The first botton that you press will
open. (The center button is the default stop)
2. Repeat step for up to 250 remotes.
9. Erase all data in memory:
Pressing and holding button RMT, the led starts flashing. Keep pressing this
button until the LED turns off. All data in memory card will be erased
permanently.
Notice: Be careful at erasing all data in the memory card. The data will be
erased permanently and cannot be recovered.
the one that works with the maneuver of
12

Publicidad

loading

Productos relacionados para Daspi CENTRAL PARA TOLDO