Daspi CENTRAL PARA TOLDO Manual página 13

CONTROL BOARD FOR AWNINGS
10. How to work
After the remote programmed in the AWNING, the receiver can work by
remote and/or button on board. Also, it can work by external button.
Work by remote
The different buttons on remote work as different commands, for example,
one button works for opening, another one for closing, the other works for Stop.
The details are shown in table 1. Working mode:
1. Press OPEN button on any learnt remote, the motor starts opening
maneuver until it reaches open limit.
2. Press CLOSE button on any learnt remote, the motor starts closing
maneuver until it reachesclose limit.
3. Press STOP button on any learnt remote, the motor will stop.
Work by external button OP/STOP/CL
External button OP/STOP/CL works similar as remote button:
1. Press external button SW1(OP terminal), the motor starts opening
maneuver until it reaches open limit.
2. Press SW1 again while opening, the motor stops. Pressing SW2(CL
terminal) causes the inversion of the maneuver.
3. Press external button SW2 (CL terminal), the motor starts closing
maneuver until it reaches closure limit.
4. Press SW1 while closing, it stops the maneuver. Pressing SW2 doesn't
cause any effect.
11. CONECT YOUR DEVICE TO THE WI-FI
NOTE: TO LINK YOUR DEVICE WITH ALEXA, SIRI OR GOOGLE HOME, BE
SURE TO CHECK THE SLASH ON OUR WEB PAGE. "DASPI.IT"
1- Descargue la APP "DASPI" desde:
13