INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- During transportation, the tilt angle of the
appliance must not exceed 45 °. Do not locate the
appliance upside down as this may damage the
compressor.
- Respect the legal provisions concerning safety
distances from other elements such as pipes,
electrical connections, etc.
- Ensure that the appliance is level with respect to
the floor.
- The appliance requires suitable ventilation in
order to work properly. Leave a space of 10 cm
above the appliance, 10 cm behind the appliance,
and 10 cm on either side.
- The plug must be easily accessible so it can be
disconnected in an emergency.
- To achieve the highest efficiency from the
appliance it should be situated in a place where
the atmospheric temperature is between 15 and
29 ºC.
INSTRUCTIONS FOR USE
BEFORE USE:
- It is recommended install the appliance in a
place where the ambient temperature is between
15-29 ºC/ 59-84ºF. If the ambient temperature is
above or below recommended temperatures, the
performance of the unit may be affected. for
example, placing your unit in extreme colr or hot
conditions may cause interior temperatures to
fluctuate. The range of 11-18 ºC / 52-65 ºF may
not be reached.
USE:
- Connect the appliance to the mains.
- The display comes on showing the temperature
inside the cavity.
- Press the increase, decrease button to set the
desired temperature.
- The appliance will start generating cold until it
reaches the desired temperature.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Unplug the appliance from the mains.
- Clean the appliance.
ENGLISH
TRANSPORT OF THE APPLIANCE
- Remove all the bottles from the interior.
- Subject all shelves with tape.
- Adjust the regulable feet at its lowest position.
- Close the door and secure its opening cannot be
done while transportation.
- Transport the appliance in vertical position. It is
advised to wrap the appliance with a blanket or
similar to avoid damages.
- Ensure that the appliance is noit inclined more
than 45º during transport.
SPECIAL MESSAGES:
- The following messages will be error codes that
could be displayed in the appliance screen:
- EE → It is displayed when the temperature
probe is short-circuited ort disconnected.
- LL → It is displayed when the temperature
detected inside the cabinet is below 0 ºC.
- HH → It is shown when the temperature is
higher than 37 ºC.
- In every error, the letters displayed will flash and
the cooling will be stopped until solution.
CONSEJOS PRÁCTICOS:
- Do not introduce hot beverages inside the
appliance. Wait until the beveerages reach the
ambient temperature.
- Close the door rapidly when using the wine
cooler. Doing this will ensure that the temperatura
change is the mínimum.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products, for
cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of the
appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.